USRobotics NETServer/16 Manual do Utilizador descarregar pdf (Página 167)

Command Reference 10-17

IP Address

This command is used to tell the NETServer what IP address

will be used by the remote device. The default is 0.0.0.0., which

disables the port for TCP/IP connections using PPP. Use the

following command.

set location <location name> destination <IP address>

PPP links: If the IP Destination is set to 255.255.255.255, the

NETServer will try to negotiate or learn the location’s IP

address. This will work only with manual and continuous

connection types. On-demand locations require a specified IP

address (to know when to dial).

Netmask

This is the IP subnet mask for the remote location. It will be

used to determine the network and host portions of the address

given above. The default is 255.255.255.0, which would be

appropriate for a Class C network with no subnetting or for

Class C size subnets of larger networks. You must change this

value if the remote location is using a different subnet mask.

Use the following command:

set location <location name> netmask <netmask>

IPX Network

While a dial connection is up, it acts like a virtual network

segment to which both the NETServer and the remote location

are attached. This is the IPX network number that will be

assigned to that virtual network segment. It is not the number of

a physical cable on either network.

The IPX network number must be unique on both the remote

and local networks; that is, no device or service may be using

that exact network number. Use the following command:

set location <location name> ipxnet <IPX network number>

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 283 284

Sem comentários

USRobotics NETServer/16 Manual do Utilizador Página 167